Your cart is empty.
Your cart is empty.Product Description
Operation
Your Fethead Phantom will latch straight onto any XLR equipped microphone, or anywhere else in the signal path between microphone and preamp/mixer. The electronics are housed in a robust metal chassis with a balanced female XLR input and a balanced male XLR output, rugged enough for use at home, in the studio or on tour.
- Allows phantom power to reach the microphone
- Adds 18dB of clean gain
- Great for mobile recording and camera microphones
Triton Audio FetHead Phantom
Preamp for condenser microphones
FetHead Phantom is an ultra-low noise, high quality, in-line microphone preamplifier. It provides improved sound for condenser microphones. Small, compact, but powerful, Fethead Phantom utilizes tried and true FET technology to deliver up to 18dB of clean boost. No more cranking your mic preamp and adding unwanted noise to get your microphone to an acceptable volume. Boost your microphone!
- Preamp for condenser microphones
- Low noise Class A FET amplifier
- 18 dB amplification (@3000 Ohm load)
- Lots of headroom
- Frequency response 30hz-100khz (+/- 1dB)
- Z-in 1000 Ω
- Circuit is powered with 24-48V phantom power
Which microphones benefit
FetHead Phantom is specially designed for condenser microphones. It works very well with all condenser microphones. FetHead Phantom is also an indispensable tool for mobile recording and a real upgrade for camera microphone preamps, because it lowers the noise floor.
Phantom power distribution
FetHead's Phantom circuit uses 48V phantom power but also passes it on from its input to the microphone. Your condenser mic is powered with the same phantom power.
Recommended applications
Our FetHead Phantom is recommended for improving the signal to noise ratio and performance in the following situations:
- Recording direct into a DAW interface
- Noisy or low gain preamps
- Mixers/preamps that negatively impact the sound at higher gain setting
- Handheld digital audio recorders
- Condenser microphones
- Miking all types of softer sound sources
Dancer
August 10, 2025
I love this little thing so much. It works with every single one of my phantom powered microphones, and it seems to boost the quality, by providing better amplification than the preamps built into my zoom H4 essential recorder.So not only do you raise the volume, but you also give a lot more separation between the audio and the noise floor.I put the inline amplifier right by the microphone, and then have the cable running to the mixer or recorder. This way it boosts the signal before it is transmitted and is less likely to pick up noise .This thing works really well, and I will buy more as I need them for my ever expanding setup. Highly recommend to anyone looking to improve their existing microphones and recording setup.
Kindle Customer
August 9, 2025
Makes my condenser sound perfect. Before I had a lot of noise. None now and the tone of it seems to be a lot better. For those who say the connection is loose then only connect it to cables and not the mic. Mine fits my cables nice and snug. Love it. I have a Cloudlifter for my ribbon and dynamics but this for my condenser is great. I also have an Aston Stealth with built in boost.
Shawnee
August 6, 2025
I needed a preamp for my condenser mics for recording in a DAW using a gen 4 Scarlett interface. It boosted the volume while allowing me to keep the gain low. It is especially useful for micing an acoustic guitar, but it's great for vocals, too.
Andrew Miller
August 1, 2025
Does the job at providing preamp for my AT2035. I have it connected to a Steinberg UR22 mk2, before I used to have to crank the gain on the Steinberg interface almost all the way up to get acceptable levels, causing the audio to lose some quality. With the Fethead hooked up, I barely need to turn the interface gain halfway to get the same levels, resulting in better quality. Normally I would've expected the opposite to happen with the Fethead increasing the noise floor, but that doesn't seem to be the case (at least to my ears).
California Summer
July 22, 2025
This thing is fantastic. I LOVE it. I have a phantom powered mic for ASMR and I had to buy two of these - one was DOA, but I just returned it via Amazon and the replacement works perfectly. I love what this has done for my sound quality, the noise floor is dropped dramatically. I can use them with my mixer, I can use them with my H4N, and it improves everything drastically.Definitely worth the purchase, just know if it arrives DOA (it's happened to at least one other reviewer besides me), the return process is swift and clean, no worries, I had a new one in a couple days and the return went through with no issues.
Suedroc
June 19, 2025
The Triton FetHead Phantom is a fantastic microphone preamplifier that is perfect for both studio and live use. It is small and powerful, and it can significantly improve the sound quality of your condenser microphones.If you are looking for a way to take your recordings to the next level, then the FetHead Phantom is a great option. It is a versatile preamp that can be used with a variety of microphones and instruments, and it is sure to provide you with professional-sounding results.
Jacob sanders
May 10, 2025
I have a super cheap condesor mic, and using the built in phantom power the gain just seemed very unclean. After using the Fethead Phantom (and a lot of finagling), I found a some really good levels to record at and without the fethead I don't think it would have been as audible or clean.
Mark Genovese
May 8, 2025
Bought this pre amp to use with my Zoom H4N recorder. I am pleased with its performance and its ability to allow me to reduce input levels on my recorder to reduce and/or eliminate hiss. I noticed a significant reduction in noise floor when using a Boya PVM-1000 shot gun mic. I also tried it with an Audio-technica AT875R shot gun and found that through level adjustments I could improve its off axis rejection or make it really hot and extend its range. A nice side benefit I found that the FetHead acted as an adapter to allow me to connect the mic to the H4n without a cable. This makes for a nice compact hand held unit for capturing foley in the field
Przemysław Józefczyk
May 5, 2025
Pierwsze próby wypadły pomyślnie. Zoom H5 ma słaby przedwzmacniacz i w zestawieniu z SM7B generuje duże szumy. Bez Fetheada gain na wejściu rejestratora musi być ustawiony na 7-8. PO podłączeniu Fetheada między 4 a 5. Dodatkowa zaleta, to możliwość wpięcia go bezpośrednio do wejścia XLR Zooma. Wpi ęcie do mikrofonu zawieszonego na ramieniu jest kłopotliwe i wymaga przedłużki. W konfiguracji z krótkim kablerm XLR ( około 1,5 m) nie zauważyłem, żeby Fethead wzmacniał szumy przewodu. Wcześniej miałem Klark Teknik CT-1 i uważam, że był wykonany gorzej. Fethead jest robiony w Holandii i w cenie Amazona naprawdę warto go kupić. Jedną gwiazdkę odejmuję mimo wszystko za cenę!
Quartermaster
May 2, 2025
Lo compré para mi microfono Sure SM7B y me ha venido genial. Mi interfaz USB de Steinberg se quedaba corto como preamplificador para este microfono y el Fethead funciona de manera excelente para añadir la ganancia requerida de manera limpia sin capturar ruido. Comprar otro interfaz bastante mas potente tecnicamente hubiera sido la mejor opción pero hubiera sido mucho más caro, no obstante el Fethead me proporciona casi el mismo resultado (casi no añade nada de ruido) y me resultó mucho mas barato. Además es pequeño y sencillo de instalar (simplemente conectarlo al cable XLR entre el interfaz y el microfono). Llevo un par de meses usandolo y estoy encantado, ya que el resultado es más que satisfactorio.Lo recomiendo!PROS:- Mas barato que comprar otro interfaz o preamplificador mas potente- Apenas añade nada de ruido con el incremento de ganancia que aporta- Muy pequeño y fácil de instalar (optimo si te vas desplazar con equipamiento mÃnimo)CONS:- Un preamplificador o interfaz diseñado para microfonos como el Shure SM7B proprcionarÃa una experiencia un poco o ligeramente mejor (aunque esto serÃa bastante más caro que el Fethead)
Ramon Esteban Baynori Sainz
March 26, 2025
Le da mucha potencia claridad y cuerpo al sonido lo utilizo con un Rohde Nt1a y una tarjeta audient Id 14 y suena fantástico
Piotr
February 23, 2025
The Triton Audio FetHead works very well with mics, which require more oomph. Most importantly, it is quiet and colourless. I purchased two of them and use both units with my ribbon mics. Pure sound, professional quality.
Teşekkürler
January 19, 2025
Bu kategoride üretilmiş tüm ürünlerden mevcut ancak bu başka bir şey kalitesi, tasarımı ve sağlamlığı ile 1 numara. Performans olarakta diğer rakipleri yanından bile geçemez
Recommended Products
$1,962.00
$ 99 .00 $99.00