Your cart is empty.
Your cart is empty.
Product information
Replacement OE part number:
84905-47010, 84840-21010, 84840-35010, 84840-47020, 84840-08010,84840-33090,84840-20010,926-098.
Fitment:
Prius 2004-2009
Sienna 2004-2010
4Runner 2003-2017
Camry 2007-2011
Avalon 2005-2012
SEQUOIA 2008 - 2018
SCION:
tC 2005-2010
xB 2004-2007
RX330 2004-2009
RX350 2007-2009
RX400h 2006-2008
GS300 2006
GS350 2007-2011
GS430 2006-2007
GS450h 2007-2011
GS460 2008-2011
LS460 2007-2012
LS600h 2008-2012
No need to replace the entire latch assembly if only the cover rubber piece of melted.
If you have any questions about the product, please feel to consult.
While this is not a genuine OEM part, it is a direct replacement and good value!
R. Carboni
2025-08-27 12:00:30
I bought this for my 2010 SIENNA, and it appears to be an exact duplicate of the OEM product. I did run into a couple of installation issues which are not the fault of this product or seller. The convenient tool supplied with this item had a different screw head interface than what they used for installing mine at the factory. The tool also did not fit into the awkward location of my tailgate switch. This might be different with later model years as the redesign occurred in 2011. The screws provided were the correct length but too narrow of a gage. I just reused the old ones. It is my recommendation that people installing this should be prepared to use alternative tools. If the old rubber cover is a gooey mess, try to remove all the pieces from around the button so the new rubber piece can effectively grip the edges of the button. It has been working fine ever since I installed it four months ago.
Paul Petrucci
2025-08-24 11:20:21
Item came just as it was listed. It works perfectly on my 2010 4Runner Trail.
David J. Hayden
2025-08-12 14:54:57
Product was good quality and worked out fine. If I were doing another one, I would get one with the switch and cover. Digging all the plastic off the old switch was a pain.
Chris Sharp
2025-05-11 11:14:02
The part is okay, but forget trying to use that tool
Carmine Campana
2025-05-08 20:40:56
The cover is good , the screwdriver that comes with it is useless..the angle of the screws on 2008 prius made the tool useless ...tossed it right in the trash
ST
2025-04-18 15:42:17
Closest to the original, sealing the circuits and enabling the trunk opening. Installation may require removing nuts from the inside of the trunk to remove the older casing. Once that is done, new installation is a breeze.
Alex
2025-03-04 12:21:04
Just one problem what I had in installation its remove old glue, but this lid fits perfectly
lori
2025-02-02 13:30:39
Fits perfect but had to remove inside panel to access the area
Recommended Products
