Your cart is empty.
Your cart is empty.MINI FUSE TAP KITS California Prop 65 - Warning, This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
Taun Taun Logistics, LLC
August 16, 2025
I used these to run a jumper from one fuse to another on my Lexus GS400 to disable the daytime running lights. It was just what I needed. I put fusetappers on each end of a wire and pushed in each tapper to the corresponding fuse. These slide in right behind the fuse next to the prongs so you can keep the fuse in its socket and also run something else through it at the same time.Makes for a very clean install.
No name
August 15, 2025
Exactly what I wanted
L. Porter
June 26, 2025
This fuse tap made hard wiring the GPS into my 2011 Chev. Impala a much easier task because there is only one fuse that works with the ignition switch in the inside fuse block and it is difficult to get to and sets back in an area with very little clearance. I had one of the double stack fuse holders that was suppose to work ... it didn't ... not enough room.
S.K.
May 5, 2025
The product works perfectly as it was intended. But it's a bit tough inserting it in to the fuse slot. The metallic prong tends to bend pretty easily, and doesn't line up with the fuse very easily. In the end, I used a bit of super glue to stick the prongs on to my fuse to guide it in to the slot properly.
Nancy H.
April 21, 2025
The photo shows 6 terminals and 2 post taps. Only came with 3 terminals and 1 tap.
Zach R.
April 8, 2025
The actual "taps" get all the glory here (little brass/metal bits that the terminal slides on to). Genius idea, tight fit but not impossible to get in. Only dislike I've had so far is when I remove the connector, it pulls the whole fuse with it.I used 1 to create a junction/distro block for switched 12v power, works like. a. charm.
trojwl
April 3, 2025
Everything I needed.
Isaac
March 22, 2025
I bough them jut to add a new fuse line to exiting fuse. THis metal leg are too big. So could not fit to the fuse slot with existing fuse. I ended up grinding on both side to make it fit. I might bough the wrong one. It did not work for me well. It was very hard to install.
Travis Benner
January 10, 2025
worked good for up fitting my quads with heated grips, winch controls, plow etc. allows use of factory fuses and are easy to install. kinda flimsy but there really is no way to make it super strong considering the size they have to be and for good electrical conductivity, softer metals need to be used. as for people bending them during install, best way is to put it against the fuse output and hold it with needle nose pliers to clamp it parallel with the fuse and install it. never bent a single one this way on install and for them to fit in my sealed fuse box they needed to bend to a 90 degree anyways so I'm glad they are easy to manipulate.
ken popp
January 4, 2025
Shop
Customer
December 5, 2024
Got them and replaced the ones on my vehicle and totally confused my coworkers and radio tech. Quote never heard of these, if discovered some auto part dealers never heard of these as well even though they sell them (package of these were on the wall display) this is why I bought them from Amazon
0
November 21, 2024
ðŸ‘
Pierre Bouchard
November 17, 2024
Good quality and a reasonable price. Would buy again
Recommended Products
