Your cart is empty.
Your cart is empty.
Package Includes:
- 5 x Mechanical license plate screws.
- 5 x Self-tapping license plate screws.
- 10 x Foam pads.
- 10 x Collors.
- 10 x Screw covers.
- 5 x Lock nuts.
- 5 x Lock washers.
- 5 x Flat washers.
- 5 x Nylon screw inserts.
- 1 x Wrench.
- 1 x Drill bit.
clinton james
2025-09-03 17:26:39
Good quality, fits as expected. Looks cheap, but they work.
Tong
2025-08-25 13:23:09
Easy to useQuality productsBut was not needed
Craig K.
2025-08-14 21:49:35
Quality seems to be very good and looks much better that some of the fasteners sold at the auto parts stores. It is a nich touch when used with a good quality license plate frame.
NICOLEASHELY
2025-07-28 14:36:15
Looks great does the job fit great worth the money
Paul E Lawrence
2025-06-26 13:50:18
Item met my requirements and full filled my needs.
Jocelyn T.
2025-06-17 12:34:25
Doesn't come with instructions an the screws keep falling out cause apparently I'm not doing it right, but can't figure it out cause there's no instructions
Edward Garcia
2025-04-29 18:28:07
I wanted some black screws for my plates
SAM AMIN
2025-04-06 13:34:39
Since my dealer is in NYC, i am in NJ, NJ plates were FedEx to me, this bolts fit perfectly in to car sockets for number plate, also the little tool is very helpful
PM
2025-04-05 21:26:52
Good quality, great fit and screws, easy to install, good value, best look
Ger
2025-03-27 12:58:06
If you have an expensive plate holder(ie: custom etc) This is totally worth it.Couple of options with either through bolts and nuts(anti-theft Torx) or screws(also anti theft Torx).Comes with new plastic grommets for the screws and bolt/screws covers(which are nice and possibly another deterrent)..Not too many have or use the theft proof special Torx tips..So it's a nice deterrent, I don't think many would bother spending the time..Safest would be the trough bolts with nuts, I would use "red" lactate..Then good luck to whoever wants to disassemble this..The Torx safety tips won't work unless one uses careful application of heat to relax the loctite..But I like this kit a lot!! AAA+++As described, arrived quick, serves the purpose of(but you can make it even better with the bolts) - but leaves ya with a few options ;-)
Rolando Reyes
2025-03-08 14:50:36
Very good product and lived up to y expectations. Car tag plate looks good and fits perfectly on the pre- drilled mounting screw holes.
John
2025-03-04 15:46:40
I like the screws, only one draw back. If you have a plastic cover over your license plate then you would need 2 longer screws. Screws 1/2 inch too short
Peter Gee
2025-02-09 21:42:51
You require some basic DIY skills and the use of a bit of logic, it will then be a straight forward installation. Very clean finish with the large black caps covering the screws. Comes with a hex drive. May not fit all license plate screw plugs (the plastic ones already in the vehicle for a plate fitment) but you can use your old screws as the black caps are extremely difficult to get off.
Recommended Products
