Your cart is empty.
Your cart is empty. Crankshaft pulley holding tool for VW AUDI
For TFSi/TSi 1.8 & 2.0L TSI petrol engines found in the VAG
Kelli Beatty
2025-08-11 14:32:08
Nice part. Did the job I needed it to do.
As advertised
2025-05-13 12:34:37
Fit perfectly on my 2011 Audi Q5 2.0 turbo engine crankshaft.
Felson99
2025-03-29 10:31:40
Needing a tool to lock the crankshaft on a 2013 Audi 2.0 turbo I ordered this tool. It worked exactly as it was supposed to without any problems. It's best to have 2 people for this operation. One to hold the tool flat against the crank pulley, and the other to do the 90°angle torque at the end of the torque sequence...yes it's made in China, but it worked exactly as it was designed to.
Very good
2025-03-11 13:39:24
Very nice
alen
2025-03-03 13:04:52
It fit for 2011 volkswagen cc but it's too short u can't open nothing unless u use extensions pipe
JD
2025-02-24 13:52:57
Worked perfectly for my 2012 Volkswagen Jetta GLI Autobahn. It will also work with any VW or Audi with the 2.0L Turbo DOHC I-4 TSI Engine. Built solid being almost impossible to bend or break on any way. I used it to remove my crankshaft pulley and can say it is a must have to do so without an impact wrench.
Brian
2025-02-20 15:11:19
Need to get the crank pulley off. This tool did the job.2015 Audi A3 EA888 Gen 3
Bruce Close
2024-11-13 16:04:56
This is a great alternative to the expensive VW tool. It’s well made and makes removing the crank pulley a breeze.
Recommended Products
