Your cart is empty.
Your cart is empty.Product Description
Akeela W
2025-09-02 10:18:19
Make sure to heat this up well before using. It imprints beautifully. Time will tell how the material hold up to continuous heating. This far it is great.1. The logo I chose and the wording came as expected. It was accurately done.2. The stamp was easy to put together3. It works as expected but you have to be sure to heat it up well before using.
jayplott
2025-07-29 13:27:05
nice piece for my wood working shop lets me put my brand out there for potential new buyers of my crafts
FZ06
2025-07-18 17:46:36
This brand is totally worth the money for a small time crafter such as myself. The image is clear and doesn't look like a burnt blob. That being said, I've seen unfair reviews where the brand was clearly applied too long. I've been trying to find a sweet spot and so far a 175°F brand held 4 seconds on leather seems to be working.There is a bit of a wait on this product but it's worth it!
Roy
2025-07-05 11:39:44
This was made and in the mail in less than 24 hours! FAST Shipped and in the mailbox 5 days after I placed the order. Quality brand with nice, sharp letters. The photo I attached was my 1st test piece. Found that best procedure was to have a piece of scrap that is the same species wood you plan on branding. Don't put any finish on the wood before you brand it. Heat the branding head until you think it's hot enough (count to 15 with head in a propane or Mapp gas torch flame). Then test it on your scrap wood. If it is too hot, the brand will look like my photo. Note that if you have some light charring around your brand like the attached photo, lightly sand the brand with 120 grit sandpaper and it will clean right up. Do another test brand without reheating the head and keep on branding your scrap until you have a crisp brand with little to no charring around your letters - then do your brand (do not reheat). You can get 2 to 4 good brands without reheating the head - that's following your test brands charring up the scrap. PRACTICE ON SCRAP until you get it right. Then and only then brand your finished product. I strongly endorse this product.
Coni Kelly
2025-07-01 18:27:53
The head didn’t have threads in it so it could be screwed onto the handle , very cheaply made , came in three pieces , the handle , the piece between and the branding head that did not have threads in it to screw the thing together . DONT BUY.
Alyssa
2025-06-19 12:49:59
The brand fell off of the rod only after an only using it on 10 of my wooden coasters. There was no way to screw it back on as the heat expanded the threads too much.
Anthony Chavez
2025-06-12 16:09:27
This product was great!!!
Joe
2025-06-08 15:04:07
This is exactly What I was looking for. It heats up nicely. The only draw back is the threaded handle doesn’t stay tight. Would buy again
Wayne Howard
2025-05-23 15:11:38
does a great brand
Kaeden
2025-03-23 11:19:23
Works perfectly
Derek R. White
2025-03-18 16:17:04
Good materials well made however so small print is illegible
Jeff
2025-01-30 16:04:31
Works great. Especially for the price, I’m impressed. Only improvement I would say it needs is for the rod to be a little thicker for stability
Wesley Brown
2025-01-24 11:24:11
I only used the 1.5†stamp a few times when the centre keep coming loose. I tried to be as careful as possible but the threads just let go so I could not longer use my stamp as the rod would not hold it any longer.
Recommended Products