Your cart is empty.
Your cart is empty.Product Description
Door Lock Actuator- Front Left Driver Side - For Cadillac Chevy GMC Vehicles - Escalade, Avalanche, Silverado, Suburban, Tahoe, Sierra, Yukon
Easy Opening And Closing Of Doors
No Longer Worry About The Door Can'T Open And Close Normally
Replace Part Numbers
15110643 --15053681 --15068499 --931318 | 931-318
Feature
Premium materials | Perfect replacement | High-quality
Tools needed
- 1. 10mm socket with long extender
- 2. Torx bit
- 3. small flat screwdriver
- 4. plastic pry-bar
- 5. flashlight
To reinstall
-Attach the key lock rod and lock indicator rod to the new actuator
-Slip the lock indicator rod up into its position in the door and attach the key lock rod back to the red clip.
-Attach the wiring harness and cable pull
-Bolt the actuator to the door with the torx bolts
-Attach the door handle rod to the yellow clip
-Reattach door panel with all wiring harnesses and the cable pull
How to install
Door panel comes off with 3 10mm bolts hidden behind plastic covers, several plastic pop clips around the sides and bottom, and then lift it up off the door to remove. Pop out the switch panel and remove connectors, disconnect wire pull attached to door handle.
The actuator is attached at 6 points: Torx bolts to door, 3 metal rods, the pull cable and the wiring harness.
-Drop a flashlight into the bottom of the door so you can see better.
-Take a picture of the actuator in the door so if you get lost, you can remember how everything is attached.
-My suggestion after doing this is to first disconnect the rod attached to the yellow clip (hint, the clip opens by pushing the tab towards the OUTSIDE of the car).
-Then unclip the rod attached to the key. Don't try to unhook it from the actuator. It is connected to a red plastic clip up at the top and can be removed by pushing the rod towards the BACK of the car.
-Remove the torx bits.
-Now you can move the actuator around within the door to unclip the pull cable and the wiring harness. The wiring harness is released by sliding the red plastic tab up. 2 rods will still be attached to the actuator, the key lock rod and the one going up to the lock indicator. Remove all from the door.
Kennith Potts
2025-06-12 12:19:41
This looked and acted just like the ones at the local part store but was MUCH lower cost. It arrived on time and works great!
ACE138
2025-06-08 21:50:34
Fit perfectly in my old Tahoe's driver door. Works like a charm. Fast and powerful. My original actuator was hit or miss and now my power locks are back! The part is not as heavy duty as the original, but for less than $24 (GM original is over $200) I am very happy! You're going to bust up your knuckles a little bit taking the old one out, but it is very doable. It's only been on for a couple days but seems like it's going to last.
ForestvilLee
2025-05-09 11:04:17
Installed on 2004 Chevy Suburban 1500 LS. Works like a champ so far.
mike kenny
2025-05-02 11:44:41
It fit and the price was right
Customer
2025-02-05 17:14:41
The left driver's door lock started working sporadically with the remote. I ordered this one, and it was a perfect fit! Plug and play. Works like a charm.
Southern Charm
2025-01-14 13:43:11
My Silverado was periodically activating the alarm. I also noticed that when I got out, the radio stayed on. I did some research and figured out that this part was most likely the culprit. I got this part and it solved the problem. It wasn't terribly hard to replace but does require some mechanical ability. I will see how long it lasts.
Primed and Delivered
2025-01-11 11:53:03
I bought this to resolve a power unlock failure in my 2001 Chevy Suburban 1500 LT driver front door lock. My vehicle has a remote/keyless entry which would only lock but not unlock. This actuator was easy to install in under an hour after watching a couple of videos online. My vehicle required a T30 Torx bit. But replacing this part didn't solve my problem. After troubleshooting further, it turned out to be a failure of a relay (DRIVER UNLOCK) in the fuse compartment in the driver side of the dashboard. But this new part works just fine and is a great price.
CallMeDaddy79
2025-01-08 18:06:55
OK...I bought a Escalade EXT and its got a bunch of stupid issues.. The one that was a pain was i had to reach over and open passenger door to shut off radio and cluster after shutting car off...Everything else worked fine so I was really unsure.. Then I found this on amazon for $25 and said screw it.It was not a easy swap... You must be pretty knowledgeable..I can give the steps... remove door panel.. go staright to the rod on inner door handle remove, then inside door for inner handle... rod sticks down to a yellow clip... clip opens up... remove the 3 plugs and pop out the wiring harness. Then you can use the torx and remove the 3bolts for latch....now lay it on the ground with the 3 rods still connected, lay the new latch down and take one rod off at a time putting onto new one...once done... slide it into position put on bolt in to hold it.. connect 3 plugs back in (this is tough, just be patient and have a flashlight) now connect the outside door rod and inside door rod...snap lock/unlock rod back into place.. tighten the 3 torx bolts.... put door panel back on...Make sure passenger door is unlocked/open just in case you messed something up...I finished this install in about 30m with no prior knowledge... I was super nervous but now its done and I couldn't be happier...This item works perfectly.... If you have a issue where the door wont unlock from fob, or like me it wont shut off accessories... This is your fix... Good Luck!!
jose granados reyes
2024-12-30 16:36:58
Es una refacción original, se instala fácilmente
VÃctor M Flores C
2024-11-14 15:10:48
Lo iba a sustituir en mi camioneta Silverado 1500 2008 pero no coincide con el anterior
Recommended Products