Your cart is empty.
Your cart is empty.Product Description
Product Features:
-Use moving-magnet principle to drive the needle, featuring good endurance and anti-vibration.
-Operating temperature: -40°C ~+85°C
-Protection rank : IP67.
How to install it ?
- Cut an 52mm (2 1/16") hole in the panel and allow a clearance of 70mm (2 3/4”) behind the panel to fit the gauge.
- Put the gauge in the hole.
- Using M4 nut and C type bracket to seal up the gauge.
How to connect wires ?
Red wire --- Power Positive.
Black wire --- Setting time.
Orange wire (backlight) --- Power Positive.
Blue wire --- Power Negative.
Please note: Clock meter can be connected to 12VDC and 24VDC power directly.
Package Includes:
1x Clock Meter
1x Multi-plug socket
1x Installation Instruction
ernieupton
July 22, 2025
Needed to replace the analog clock on the boat...same model new was stupid expensive (for I use it for), then I found this... hands are red, so it doesn't match the rest of the gauges, but install was easy, lights work with other gauges, and it's 'digital with analog read out'. you adjust the time by pressing a button on the back. This would not be easy for me, so I also purchased a small flush mount momentary switch, mounted in dash panel...and it hardly shows. First season and it kept great time!
Joe Dirt
June 3, 2025
In total darkness wherever the hour hand is, it's so bright you can't see the number it's pointing to and looks fuzzy. When the minute hand is near the hour hand it's even worse. If it had better backlightimg, I would give it a 4. If it also had external (face) clock adjustment, I would give it 5 stars. However since it's $125 cheaper than the Autometer clock I was looking at, I'm overall ok with it.
Melissa
May 24, 2025
This clock fits any common 2" - 2 1/16" (52mm) Consoles and dashboard Pods.Excellent quality, glass face, chrome ring and well made.This clock has a hour hand and a minute hand.
David azevedo
May 21, 2025
I like it during the day but at night the red backlight is so bright it's hard to find the hands
Jo Jo
February 12, 2025
Clock bezel is too small to cover hole where the previous clock was mounted. Leaves a gap.
David Beyers
January 21, 2025
Installed in wood dash of a 1978 Triumph Spitfire I'm restoring. Looks like factory and matches other gauges trim. I wired it into dash lights and it Looks totally boss! Keeps accurate time as well! Great value for the price and performance. I'm going to order another one for my 4x4 truck and mount in a 3 gauge mount with oil and voltage gauges, should be awesome too.
Eduardo
December 21, 2024
Baja calidad
Recommended Products
$165.63
$ 75 .99 $75.99