Your cart is empty.
Your cart is empty.Micro duct, PVC, nylon, polyethylene and other plastic tubing cutter for general purpose and automotive applications. Tool works great on vacuum hoes as well as fuel lines.
J
July 24, 2025
It works really well.
B. A. Egan
July 8, 2025
I use this tool to cut 4mm PTFE tube with a 0.5mm wall. With it, I can make straight cuts every time with minimal deformation in the material. I am satisfied with the results of my work and the quality of the tool.
FushigiMigi
June 29, 2025
Works and is affordable, but closing latch is trash. If you drop it into your tool drawer, it will unlatch and spring open. There are some designs that I can forgive, but this one should have been detected by the engineers/technicians that designed this during testing.
1234
June 26, 2025
Perfect for PTFE Bowen Tubes in a 3D Printer. This is what I purchased the tool to cut. Have used it and can confirm it's smooth and perfect size.The tool is well made and should last for years. I don't know where to purchase replacement blades, but the blade is held in by a couple of fasteners and can be removed, sharpened, re-installed. Or if a suitable source for replacement blades is found, the blade in this tool can be replaced easily.
Casey
June 12, 2025
These are handy little cutters. Perfect for cutting the 1/4 plastic lines we use. However, you get what you pay for. These are made out of cheap plastic (who knew🤷ðŸ»â€â™‚ï¸ðŸ˜‰)But after a week the little lock broke and can’t keep them closed. I carry them in my pocket and need them to stay closed. It wasn’t fun finding out the lock was broke🩸🩸â˜ï¸.If they are going in a tool bag or box they will be a great tool (nice and small).
Todd
May 28, 2025
If your hooking up drip irrigation system buy one of these. Makes cutting the hoses quick and easy. Snips through 1/4 and leaves a nice square cut. Glad I bought these!
Chris
May 13, 2025
You can not go wrong with this company!
Serious
March 30, 2025
Crisp clean cut, in a pliers format. The blade is replaceable. They are plastic, but adequate strength for their designed use.
Mehmetbb38
February 16, 2025
Ich kann nur 2 mal benutzen. Das ist einfach Müll.
Customer
February 14, 2025
We needed for 14/10 microduct which it says it can cut. Both sets fell apart within 2 weeks. The larger Jonard cutters are fantastic however.
Jorge
January 28, 2025
La única pega es que según la imagen la cuchilla es reemplazable, en el que recibà esto no es asÃ
ray fitzpatrick
January 25, 2025
Very good and easy to use..cuts through the pipe with ease
Recommended Products
