Your cart is empty.
Your cart is empty.Product Description
MrTast3less
2025-08-18 18:49:47
The quality is top-notch, and the fit and finish are near perfect (a few of the clips were a bit harder to re-install) the gaps on the flares to the painted surfaces are excellent.Overall took me about 40 minutes to install, the instructions are very good with color pictures.
C.G.
2025-08-17 15:08:52
The fender flares are great. They are a great size, not too big that they cover too much over the wheels, not too thin that they don't add any "flare." Like in Goldilocks, these are just right.They were fairly easy to install. Install of all four should take about 30 minutes or less. I added some PPF film to the contact points with the paint, so it took my about an hour. The instructions were clear and easy to follow. The tool provided to remove the clips worked well.Overall, the flares look great on the truck. The reason this is not a perfect 5 and I knocked down 0.5 stars is because the front flares are a bit "short." In the last picture you can see how the front flare leaves a sliver of paint showing, the flare does not cover the entire paint area. Some black vinyl strips underneath will take care of it, but since the rear flares were fit properly, it shows that they are able to make the front also cover properly.However, these cost about 1/3 the price of what dealers are selling, so I am not going to complain too much about a slight fit concern.
buyer
2025-07-27 15:03:07
As others have noted, these aren't a perfect fit. Both my left side flares required some hole drilling, the existing holes were badly out of alignment. The tape along the bottom edge of the front flares isn't holding firmly to the fender and will have to be redone with a slightly thicker VHB tape and some adhesion promoter. There were small gaps that show exposed paint, especially at the bottom of the rear fender. The flares should have extended a bit further here for better aesthetics. All said, they look pretty good after installation and were considerably less expensive than other flares currently available for the Maverick.
cpreis
2025-05-27 09:15:47
This is a well made kit, and it looks great. My picture doesn't do them justice. Installation is straight forward and fit well with my mudguards. If you have mudguards, you'll need to make sure to save the longer fasteners for re-installation.
Steven M. Joseph
2025-03-30 10:53:41
These look great. The extra protection for the sides of my truck is well worth it. Honestly Ford should have made these stock.
Justin C.
2025-03-27 18:17:03
I initially left a review praising these flares but I've changed my tune. These Mabett flares scratched my paint very badly in just a few weeks time with proper installation. In some parts, the paint was damaged beyond a what simple polish could remedy. It's just not worth it IMO. I took them off and threw them away.One could install paint protection between the flares and the painted surface but that will still require annual maintenance, it's not a once and done thing. If you just throw these flares on and forget about them, you will have paint issues before long. Eventually the damage will spread and be visible beyond the flares. What will you do then? Install the larger flares that look ridiculous? Repaint all four fenders?I realize that these are very appealing due to their low price but I don't think most realize just how much damage these will do over time. Some mentioned sanding down the edges to prevent damage, the reality is that’s only half of it. Even with the edges sanded down, debris will still collect and ultimately cause damage to your paint. There’s no way around it aside from PPF between the flares and the paint.
James Oehmke
2025-03-18 18:06:05
Installation was very easy. Once installed changed the way my truck looks and very happy with the look. Purchased more for looks than protection from items being kicked up by the tires, but I am very happy I purchased these.
Kyle Littlefield
2025-01-04 16:21:28
They fit the contour of the wheel well good, but isn’t consistent with the holes on the fenders needed to re-drill some. Also quality is ok but some need to be ground on the inner lip to fit flush
Bill Gordon
2024-12-20 17:53:34
after shopping about online & the ford dealership i came across Mabett, i took the plunge & went for it also reading all reviews as well. i already had put on mud flaps which i had to take a few clamps off first to get the guards underneath but no worries. i put a few clips on first to hold the guards in place so i could adjust to the best position then i peeled back the 3m tape once satified & pressed them on for good. then i put on the remainder clips & good to go. looks good saves some stone chips im hoping & value added to the vehicle.
Guillaume G
2024-12-15 18:21:24
More than half of the clip holes does not align and the upper edges are not evenly sanded. This is doing an hour job into a 4 hour job after sanding, cutting and trimming.Do yourself a favor. Save some more and go buy something else.
Recommended Products