Your cart is empty.
Your cart is empty.Product Description
Instructions for Installation of Parapet Anchor:
1. Remove the detent pin and adjust the arm back far enough to allow the clamp to fit over the width of the parapet wall.
2. Make sure the inside top surface of the anchor slot is completely seated on the parapet wall.
3. Move the adjustable arm toward the parapet wall and replace the locking pin through the appropriate position setting holes.
4. Twist to tighten each set screw until it contacts the parapet wall, use hands to tighten each screw until it is secure. Excessive torque can damage the wall or the parapet wall anchor.
*If the anchor is not installed properly, it will not hold the rated loads and serious injury, or death, could occur.
LIGHTWEIGHT
The Malta Dynamics Parapet Anchor is made from durable galvanized steel and features large rubber pads on the tightening screws for a secure non-penetrating anchor design.
EASY INSTALL
The Parapet Anchor can be installed in as few as two minutes! There are no special tools or fasteners required for a successful install, and dual tightening handles create even force distribution.
NO DAMAGE
Staying safe should be your priority. Sometimes it’s hard to anchor safely without damaging the surface you’re working on, but this anchor leaves no lasting damage.
Premium Benefits:
- Dual tightening handles for even force distribution
- Protective pads eliminate damage during install
- Flange width adjustable from 2.36”-14.1”
- Includes extendable arm
- Non-penetrating anchorage design
- No installation tools required
Parapet Anchor Features
· Lightweight, portable, and reusable
· Worker weight capacity range: 130-310 lbs.
· Minimum tensile breaking strength: 5,000 lbs.
· No fasteners needed
· Material: galvanized steel
· Pad material: rubber
Certifications
· ANSI Z357.18-2017 Type A
Doug Pearson
2025-02-15 18:43:41
Very sturdy and well built.
Recommended Products