Your cart is empty.
Your cart is empty.Des:
Features:
Billet aluminum column shifter, tilt lever, turn signal lever, hazard knob kit.
All levers and knobs are made from billet aluminum and, polished.
Shafts are made from stainless steel and polished to match.
Fit for Original gm Columns 1967 to 1994
Fit for Chevrolet Buick and Cadillac
These are aftermarket columns that fit for GM 1967-1994 column, do not fit van columns.
How to Install:
1) Locate the bottom of shifter lever.
2) Drive the rivet out slowly. Be careful there's a spring, don't let it goes flying when removing.
3) Gently remove lever. Get a pin out.
4) Install back new lever. Same way to replace the turn signal and tilt lever.
Customer
2025-08-23 11:00:36
works good
William jones
2025-07-28 19:10:44
Did not work on my 96 gmc 1500
D & M
2025-07-08 17:41:37
LMC sell thes for a lot more money. I used these for my 87 Suburban and shifter has a nug fit but works well since ny original shifter was kinda worn out, its definitely an improvement.
Michael Taylor
2025-06-10 11:56:17
Worked great
shane knight
2025-05-20 15:44:58
Can’t use the turn signal one without deleting cruise control and wiper functions and the hazard threads are wrong… the shifter and tilt wheel are good though
ilija kovacevic
2025-05-03 14:43:00
None of these parts fit at all even after being told these would fit the vehicle! Absolute garbage!!!
S
2025-02-01 14:53:52
All scratched and knicked up
Recommended Products
$112.00
$ 55 .99 $55.99