Your cart is empty.
Your cart is empty.EMW0052119
Happystains
August 27, 2025
Arrived, was as described. Cut this down into some keyways for a Harley Servicar rear hub assembly. Made enough for both bikes and gave the rest to dad. Much better price than hardware stores or big box stores in our area.
Tal
August 16, 2025
Nice to have a 12 inch piece so I can cut it to any size I want definitely gonna order more
Matt
July 8, 2025
Not much to say here. I needed a small piece of 1/4" keystock to replace one that got bend on a commercial mower when the pulley flew off. This did the trick without any issue, and I have another 8"+ left over.
Glen Marcum
June 12, 2025
Fast delivery exactly as described
M. Hurt
May 29, 2025
Using as a shaft to drive a coffee basket, I am trying to build!
Customer
May 8, 2025
I double checked the dimension with the groove in the pulley and drive shaft.
Marc J Chabot
May 4, 2025
This is just as described, 1/4 square by 12" long. I needed a short key for my Rhino cp60 flail mower shaft. I found the part (about 1.4" long) on German-bliss equipment for $4.95 + about $23 shipping. Once I realized what it was (and destroyed a few in the process of the repair) I bought this 12" piece and cut the size of key stock that I needed. I broke a few more before I finally figured out what the problem was. Now I still have about 8" left to make more keys if I have any more problems. With Prime free shipping, I saved a lot with this key stock.
Clay C.
February 19, 2025
This is off a brake disk on a 1 inch axel on a light go-kart. Now the coller did loosen allowing it to move out a bit and twist. I put a new one in but checked it first and my original stock was MUCH harder steel then this. This steel is to soft to depend on.
Recommended Products
