Your cart is empty.
Your cart is empty.Product Description
About the PTFE Tubing:
Elongation: 150~400%
Compressive Strength: 12Mpa/1740Psi
Max Operating Temperature: 240℃/464°F
Application: Widely used in guide rails, electrical insulation at various frequencies. as gas and liquid conveying tubing, lining tubing, heat exchanger tubing, use in machinery, electronics, valves, etc.
Features of PTFE Tubing
1. PTFE Tubing can transport gas or liquid under high temperature.
2. PTFE is a good electrical insulating material with heat resistance.
3. It has good aging resistance, non-stickiness, smooth conveying of gas and liquid.
4. PTFE is a friction-reducing and self-lubricating material with a low friction coefficient and good lubrication.
Tigerdog
August 20, 2025
Not just for 3D printers, these PTFE tubes are perfect liners for bicycle cables that run inside frames (like Klein bikes) and for protecting exposed cables. Used in this way, they made a notable improvement in shifting on my older MTB by reducing friction. For bikes with exposed and/or internally routed cables, this size is perfect.
Mark Estrada
July 22, 2025
Gotnthis for my 3D filament printer and it makes it so much easier to see the filament go in and any strands or fragments left in the tube when removing and replacing filament. Filament feeds easire with less friction and my original 2mm ID blue tube.
Patrick Marcum
July 7, 2025
The tubing is described as bendable and shown as such in product pictures.The tubing is not bendable and kinks extremely easy, making it unusable for advertised application.Would look elsewhere if you are needing a more flexible tubing, especially for 3D printing.
fangleman
June 15, 2025
Packaged poorly. 1 of 2 packages arrived kinked. Therefore, it doesn't work for intended purposes like feed tubes for 3D printers. However, the tube quality otherwise seems fine.
JarrettV
March 9, 2025
For use with reverse bowden on 3d printer and could not easily pull filament through the tube. Old stuff works fine. I expected there to be less friction.
Adam T.
February 24, 2025
This works very well for a 3D printers feed tube supplying a direct drive print head. The large 3mm id of this tube prevents the 1.75mm filament from binding during the feed process. Binding in the feed tube can introduce inconsistent extrusions. The OD is the same as most other tubing so your existing connections work. The material is very transparent which is great to see the filament currently being fed. Packaging isn’t the best and I removed one star because out of the 2 I ordered, 1 came creased in a few locations.I would not use this for a remote drive setup because it could introduce binding with the extra room, for remote drive use a 2mm ID tube.
Andrei
December 7, 2024
I used this tube as a reverse bowden, to feed filament into my hotend on my corexy printer. I used about 3.5ft of the tube. It always felt a bit 'dry' and had a lot of friction when filament was in it. Multiple times I had my BMG clicking and discovered there was so much friction in the tube that it couldn't pull it through.Went back to a Capricorn PTFE tube and had no issues.
GM
November 29, 2024
Arrived kinked, tolerance varies quite a bit.
Recommended Products